Table of Contents
Advertisement
8-3 Rubber Pad Installation
When placing the control unit horizontally, the Rubber Pad (Provided) is installed at the side
of the air vents. Install the control unit so the air vents are underneath the control unit.
When installing horizontally, remove the 4 screws on the Control Panel and remount the
panel at a 90° Angle.
Before removing the control panel be sure the Power Switch is OFF and remove the Power
Inlet Cord.
Rubber Pad
Fig. 16
CAUTION
Never install the air vents upward when installing the control unit horizontally.
This may cause damage to control unit.
8-4 Proper Clearance
When installing 2 or more control units in the machine cabinet make sure to check that each
single control unit has the proper clearance on all sides.
Vertical mounting
DIR
RESET
GEAR
CTRL
DIR
START
STOP
min.30mm
min.20mm
Fig. 18
15
Control Panel
Screw
Fig. 17
Horizontal mounting
min.30mm
min.20mm
Fig. 19
POWER CORD CONNECTION
9
WARNING
Only use grounded power sources. Failure to properly ground the unit may result
in electric shock, injury, fire and/or damage to the system components.
(1) Insert the female plug into the main power inlet box
(2) A screw hole is provided on the lower, right side of the control unit for attaching the
tension relief. Use the provided Nylon Tension Relief to attach the power cord to the side
of the control unit.
Nylon Tension Relief
MOTOR CORD CONNECTION
10
(1) Align the guide pin A on the motor plug with the key way B on the motor socket on the
front of the control unit.
(2) Screw in the coupling nut C of the motor plug to the motor socket D on the front of the
control unit.
A
C
Fig. 21
CAUTION
Before connecting the motor cord, make sure the power source is switched off.
[ 10 ]
on the front of the unit.
[ 10 ]
Fig. 20
B
D
Fig. 22
16
Advertisement
Table of Contents
