Setting Of Operating Parameters - Nakanishi iSpeed3 Operation Manual

20 . SETTING OF OPERATING PARAMETERS

20 - 1 .
The following operating parameters can be preset depending on the application requirements.
The operating parameter presets are retained in non-volatile memory and will be maintained
even if power is disconnected.
Setting the Error Output Mode
When an operating error occurs, an Error Signal will be output to Input/Output Connector A
This output can be set to normally ON (Closed) or normally OFF (Open).
This signal can be output through Pin 8 .
Setting AUTO Mode Motor Speed Control
Control Mode is set to AUTO.
• Motor Speed can be controlled by the Motor Speed Adjustment Button
Setting Fixed Motor Speed for Motor NO. 1 and NO. 2
• Single Motor Speed is set.
• Machine Operator can not change Motor speed while in AUTO Mode.
Setting the Maximum Motor Speed for Motor NO. 1 and NO. 2
• Set maximum Motor speed to the maximum allowable speed for the cutting tools being used.
• Set the maximum Motor speed to the maximum recommended speed for the material being machined.
Selection of External Input / Output Signal Speed
External Speed Signal when in AUTO Mode: Speed can be changed change manually at the Control Unit,
variable DC voltage, speed change with Pulse or change at Speed Point can be selected.
Speed change using Speed Point is a method to select speeds using the four ( 4 ) rotation speeds preset
according to the External Signal (SEL 0 / 1 ).
Speed change by pulse is set with the External Signal (CNT-IN/UD-IN).
Selection of the type of External Signal for Motor start method
Allows selection of Start Signal and Direction Signal or REV. Start and FWD. Start Signals.
Selection of Motor Speed Acceleration Time and Deceleration Time
Select Acceleration Time/Deceleration Time in seconds.
Selection Emergency Operating Function
Motor rotation is stopped by Emergency Stop Signal.
Setting the Level of Speed Achievement
Motor rotation Achievement Signal (COIN) is output according to Motor Achievement Level.
Error History
Display of up to 5 previous Error Codes.
Up to 5 error codes can be memorized.
29
on the Control Panel.