Welbilt Frymaster FilterQuick FQE30-T Installation, Operation And Maintenance Manual page 26

Note the temperature on the thermometer or pyrometer. Actual temperature and

pyrometer readings should be within ± 5ºF (3ºC) of each other after allowing the heat to cycle

on and off three (3) times. If the temperature is still out of tolerance, contact a Factory

Authorized Servicer for assistance.

4.5

QUARTERLY CHECKS AND SERVICE

4.5.1

Clean the Frypot and Heating Elements

Never operate the appliance with an empty frypot. The frypot must be filled to the fill

line with water or cooking oil before energizing the elements. Failure to do so will result

in irreparable damage to the elements and may cause a fire.

4.5.2 Replace the O-rings

Replace the O-rings on the filter connection (see Figure 10 in section 3.4.2).

4.5.3 Clean (Boiling Out) the Frypot

During normal usage of your fryer, a deposit of carbonized oil will gradually form on the inside

of the frypot. This film should be periodically removed by following the Clean (boil-out)

procedure Refer to sections 2.3.10 and 2.3.11 of the FQ4000 Controller Operation Manual) for

specific details on setting up the controller for clean (boil-out) operation.

Allow oil to cool to 100ºF (38ºC) or lower before draining to an appropriate container for

disposal.

Never leave the fryer unattended during this process. If the solution overflows, press

the ON/OFF switch to the OFF position immediately.

Ensure that the frypot is completely free of water before filling with oil. When the oil is

heated to cooking temperature, water in the frypot will cause splattering.

DANGER

WARNING

DANGER

4-3

Table of Contents