Dc Power Input Connector; Expansion Port - Avaya ArgentPhone Hardware Reference Manual

ArgentPhone Hardware Reference Manual
DC P I C
OWER NPUT
The ArgentPhone 8 uses a 12V 1A Plug Top PSU module to provide DC power. This
unregulated DC is fed into the unit via the DC Input port. The DC input connector on the
ArgentPhone 8 is BLACK as is the corresponding 2.5mm Jack connector on the Plug
Top PSU module.
This port is labelled:
The ArgentPhone 16 and the ArgentPhone 30 use a 16V 2.1A Lump-in-Line PSU
module to provide DC power. This unregulated DC is fed into the unit via the DC Input
port. The DC input connector on the ArgentPhone 16 and the ArgentPhone 30 is BLUE
as is the corresponding 2.5mm Jack connector on the Lump-in-Line PSU module.
This port is labelled:
E P
XPANSION ORT
The ArgentPhone 8, the ArgentPhone 16 and the ArgentPhone 30 has one Expansion
port. This is located on the rear of the unit and is labelled as follows:
The Expansion port is used to connect the ArgentPhone 8, the ArgentPhone 16 or the
ArgentPhone 30 to any of the Argent system unit Expansion sockets.
When combined with the ArgentOffice range of products, the ArgentPhone 8, the
ArgentPhone 16 and the ArgentPhone 30 provides the user with a comprehensive range
of telephony services.
The ArgentPhone 8/16/30 is supplied with an Expansion Interconnect cable.
The cable used to connect the ArgentPhone unit to the main system unit must
NOT exceed 1m in length.
14
ONNECTOR
EXPANSION
Revision 6