TELECO AUTOMATION TVDLC868A01 Manual page 10

WARNING: READ CAREFULLY THIS INSTRUCTIONS BEFORE INSTALLING AND COMMISSIONING THE PRODUCT. SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
PRODUCT INSTALLATION
The product at issue must be installed, commissioned and maintained only by licensed and authorised
people, respecting the laws concerning the electrical installations. The product must be placed inside a suitable flush mounting box. Not conforming installations, wrong adjustments or product alterations may cause
fire, electric shock, or personal injuries. The manufacturer is not responsible for any damage due to wrong installation or improper use. Attention: at the power-on the device resumes the status it had before the
turning-off.
ELECTRICAL CONNECTIONS
All the connections must be rated for a single-phase 230V~ power supply, with the relative Earth connection. For the disconnection from the power line, use an all-pole switch with contacts having a dimension of at
least 3,5mm. Arrange all the necessary safety devices and use only materials complying with the standard of electrical installations. The cable must have a section properly rated according to the load connected.
Attention: If any cable is damaged, it must be immediately replaced by a qualified person in order to avoid any hazard. manufacturer reserves the right for changing technical data and features without prior
notice.
SAFETY INFORMATION
Do not operate in the high voltage area of the electronic board, when it is supplied. Use the product only in combination with devices which can guarantee a safe extended time functioning. The radio signal reception of the device
could be disturbed by the presence of electrical disturbances being transmitted by other appliances working on the same frequency or if the product is somehow shielded by metal parts.
PRODUCT DISPOSAL
At the end of this product's useful life, it must not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and electronic equipment. It is the user's responsibility to dispose of this appliance through the
appropriate channels at the end of its useful life. Failure to do so may incur the penalties established by laws governing waste disposal.
Hereby Teleco automation s.r.l. declares that the product complies with the essential requirements and other relevant provisions, established by the Directive 1999/5/EC. The declaration of conformity can be consulted
on the web site: www.telecoautomation.com/ce. In the view of a constant development of their products, the manufacturer reserves the right for changing technical data and features without prior notice.
10