Overland Tandberg NEOxl 40 Instructions
  1. Manuals
  2. Brands
  3. Overland Tandberg Manuals
  4. Network Hardware
  5. NEOxl 40
  6. Instructions

Overland Tandberg NEOxl 40 Instructions

3u tape library, spare base module controller
Hide thumbs Also See for NEOxl 40:
1
2
3
Table of Contents

Advertisement

Quick Links

Download this manual
Spare Base Module Controller Instructions
This document describes how to remove and replace a Base
Module Controller in a NEOxl 40 3U tape library from
Overland-Tandberg.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working with
the library.
WARNUNG:
Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT:
Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the library, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.

Prepare the Library

Save the Configuration

Before you start, save the current library configuration. If not
possible because of the controller failure, a previous version
can be used.
NOTE: Using the RMI to restore the configuration is the faster
recommended process.
1. If using the OCP to save the configuration file, insert a
USB drive into one of the USB ports on the Base Module.
2. Navigate to the Save Configuration screen.
• If using the RMI, go to Configuration > Restore Defaults
> Save / Restore Config to file.
• If using the OCP, go to Configuration > Save / Restore
Library Config > Save to/Restore from USB.
3. Select the destination location for the download:
• The RMI downloads the configuration file to the
browser or system running the RMI.
• The OCP downloads the configuration file to the USB
drive inserted into the USB port.
4. Click Save.
10400902
©2019 Overland-Tandberg
NEOxl 40 3U Tape Library
OCP Screen
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NEOxl 40 and is the answer not in the manual?

Questions and answers

Related Manuals for Overland Tandberg NEOxl 40

Summary of Contents for Overland Tandberg NEOxl 40

  • Page 1 NEOxl 40 3U Tape Library Spare Base Module Controller Instructions This document describes how to remove and replace a Base Module Controller in a NEOxl 40 3U tape library from Overland-Tandberg. WARNING: To reduce the risk of electric shock or damage to equipment, always remove any power cords while working with the library.
  • Page 2 NEOxl 40 Spare Base Module Controller Instructions Power Off Library If still running, power off the library from the Base Module front panel by pressing and holding down the power button for three (3) seconds. NOTE: If the library does not perform a soft shutdown, press and hold the power button for 10 seconds.
  • Page 3 NEOxl 40 Spare Base Module Controller Instructions Verifying the Installation and Configuration Check the following: • Verify that the library powers on and initializes correctly, and that the status is Ready. • From the OCP or RMI, verify that the Base Module is visible showing all the tape drives and both magazines.

Table of Contents