Overland Tandberg NEOxl 40 Instructions

Spare Expansion Module Controller Instructions
This document describes how to remove and replace a
Expansion Module Controller in a NEOxl 40 3U tape library
from Overland-Tandberg.
WARNING:
To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working with
the library.
WARNUNG: Um das Risiko eines elektrischen Schlags oder
Schäden am Gerät zu vermeiden, ziehen Sie stets den
Netzstecker, bevor Sie an der Einheit arbeiten.
AVERTISSEMENT: Pour réduire le risque de choc électrique
ou endommagement de l'équipement, retirez toujours les
cordons électriques en travaillant avec l'appareil.
CAUTION:
While working with the library, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.

Prepare the Library

Identify the Failed Component Module

Using the RMI or OCP, activate the Unit Identification (UID)
LEDs to locate the appropriate Expansion Module containing
the failed component.

Power Off Library

If still running, power off the library from the Base Module
front panel by pressing and holding down the power button for
three (3) seconds.
NOTE: If the library does not perform a soft shutdown, press and
hold the power button for 10 seconds.
Verify that the Robotic Assembly is in its parked position and
that all host processes are idle.

Remove Cords and Cables

Disconnect all cables and cords, noting where they connect.
1. Unplug any AC power cords (1).
2. Remove the expansion interconnect cables (2) from
the Expansion Module and any other modules to which it
is connected.
NOTE: Completely remove the expansion interconnect cables
from the modules to prevent damaging the cables during
module removal and replacement.
10400903 ©2019 Overland-Tandberg
NEOxl 40 3U Tape Library
1
2
Page 1 of 2