1. Manuals
  2. Brands
  3. Overland Tandberg Manuals
  4. Control Unit
  5. NEOxl 40
  6. Quick start manual

Overland Tandberg NEOxl 40 Quick Start Manual

3u expansion module
Hide thumbs Also See for NEOxl 40:
1
2
3
4
5
6

Advertisement

Table of Contents

All support and warranty is handled by TOLIS Group, Inc.
Warranties are provided by TOLIS Group, Inc. and can be found at:
www.tolisgroup.com/documentation.html
For warranty, RMA assistance, or technical support help, please visit:
www.tolisgroup.com/support.html

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NEOxl 40 and is the answer not in the manual?

Questions and answers

Related Manuals for Overland Tandberg NEOxl 40

Summary of Contents for Overland Tandberg NEOxl 40

  • Page 1 All support and warranty is handled by TOLIS Group, Inc. Warranties are provided by TOLIS Group, Inc. and can be found at: www.tolisgroup.com/documentation.html For warranty, RMA assistance, or technical support help, please visit: www.tolisgroup.com/support.html...

  • Page 2: Unpack The Module

    Gewichts des Moduls, dass mindestens This document describes how to add an optional Expansion zwei Personen das Modul aus der Verpackung heben. Module to a NEOxl 40 (3U) tape library system. AVERTISSEMENT: En raison du poids du module, il est...

  • Page 3: Determine Installation Location

    If you have not yet determined the architecture of Step 3 your configuration, refer to Chapter 1, “Supported in the NEOxl 40 Tape Library Administrator’s Configurations,” Power Off Library Guide for details. 1. Using the mechanical lifter, remove the existing module from which you are removing the cover plate.

  • Page 4: Install The Rack Rails

    Quick Start Guide Step 4 Step 5 A NEOxl 40 3U Expansion Module comes with a rack kit for Before inserting the module in the rack, install any optional easy installation and securing of the module into a 19-inch components.
  • Page 5 NEOxl 40 3U Expansion Module Quick Start Guide Install Optional Tape Drives 2. Slide the module onto the rail flanges and into the rack until it stops. If the Expansion Module comes with any tape drives: 1. At the rear of the library, remove the appropriate tape drive covers.
  • Page 6 3. Load the cartridges into the magazine. the firmware and Release Notes. 4. Using the magazine access handle and supporting it 5. Update the firmware using the NEOxl 40 Tape Library underneath, position the magazine on the alignment Administrator’s Guide.

Table of Contents