Troubleshooting - LawnMaster GT1238 Operator's Manual

TROUBLESHOOTING

If your grass trimmer does not seem to operate properly, first consult the
Troubleshooting Table below.
If the solution to your trimmer problem is not found in the Troubleshooting
information, take the trimmer to a qualified service dealer for inspection
and possible repair.
WARNING
Before proceeding, switch off and unplug.
Tool runs slowly
• Check that the spool housing can rotate freely. Carefully clean it if necessary.
• Check that the trimming line does not protrude more than 4 inches from the spool housing. If it does,
cut it off so that it just reaches the line trimming blade.
Automatic line feed does not work.
• Keep the tabs depressed and remove the spool cover from the housing.
• Pull the trimming line until it protrudes 4 inches from the housing. If insufficient trimming line is left on
the spool, install a new spool of trimming line as instructed above.
• Align the tabs on the spool cover with the cut outs in the housing.
• Pushing the cover onto the housing until it snaps securely into place.
• If the trimming line protrudes beyond the trimming blade, cut it off so that it just reaches the blade.
• If the automatic line feed still does not work or the spool is jammed, try the following suggestion:
• Carefully clean the spool cover and housing.
• Remove the spool and check if the lever can move freely.
• Remove the spool and unwind the trimming line, then wind it on neatly again as describe above.
Replace the spool as instructed.
18