Maintenance - LawnMaster GT1238 Operator's Manual

MAINTENANCE

Your grass trimmer has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
WARNING
Before proceeding any maintenance, switch off and unplug to tool.
• Regularly clean the ventilation slot in your grass trimmer using a soft brush or dry cloth.
• Regularly clean the
• Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.
WARNING
When servicing, use only identical replacement parts. Use of any other
parts may create a hazard or cause product damage.
Fitting a new spool of
• Unplug the grass trimmer
• Keep the tabs
① depress thumb tabs and remove the spool cover ② from the housing ③ Remove the empty.
spool ④ from the spool cover .
• Remove any dirt and grass from the spool cover and housing
• Taking the new spool and push It into the boss in the spool cover. Rotate the spool slightly until it
is seated.
• Unclip the end of one of the trimming lines and guide the line into one of the eyelets ⑤. The line
should protrude approx. 4 inches from the spool cover.
• Unclip the end of the other trimming line and guide the line into the other eyelet. The line should
produce approx. 4 inches from the spool corner.
• Align the tabs ① on the spool cover with the cut outs ④ in the housing.
• Push the cover onto the housing until it snaps securely into place.
Fig.15
trimming line and spool using a soft brush or dry cloth.
trimming l
ine (See Figure 15 & Figure 16.)
Fig.16
16