LawnMaster GT1238 Operator's Manual page 17

MAINTENANCE
NOTE: Use LawnMaster replacement spool; part # RS0101
Winding new line onto a spool(See Figure 17 & Figure 18 & Figure 19.)
• Only use .065" replacement line
• You may wind new trimming line onto an empty spool.
• Replacement packs of trimming line are available from dealer.
• Remove the empty spool from the grass trimmer as described above.
• Remove any remaining trimming line from the spool.
• First feed 4 inches of trimming line ⑥ into the two eyelet ⑦ in the upper section of the spool as show
• Wind the trimming line onto the spool in the direction of the arrow. Make sure to wind the line on
neatly and in layers. Do not criss-cross.
• Feed trimming line ⑥ into the two eyelet ⑦ in the upper section of the spool as show
• Finish winding, Produce as described above to fit the spool on the grass trimmer. Do not forget to
release the trimming line from the parking slot.
⑦
WARNING
Only use the appropriate type of
STORING THE TRIMMER
• Clean all foreign material from the trimmer.
• Store it in a place that is inaccessible to children.
• Keep away from corrosive agents such as garden chemicals and de-icing salts.
⑥
Fig. 17 Fig. 18
trimming line.
17
⑥
①
Fig. 19