Cleaning The Milk Container; Descale - DeLonghi ESAM6620 Manual

Please note:
as shown in the figure.
7. Once inserted, make sure the
two red buttons have snapped
out.
8. Replace the drip tray and
grounds container.
9. Close the service door.

Cleaning the milk container

Clean the milk container regularly as described
below:
1. Turn the milk container lid clockwise then
remove it.
2. Remove the milk
spout and intake
tube.
3. Remove the
container pointer
by pulling it
outwards.
4. Wash all the
c o m p o n e n t s
thoroughly with
hot water and
mild washing-up
liquid.
All components
can be washed
in a dishwasher,
placing them in
the top basket of
the dishwasher.
Make sure there
are no milk residues left inside the holes and
the groove on the fine end of the container
pointer.
5. Check that the intake tube and spout are not
clogged with milk residues.
6. Replace the container pointer, milk spout and
intake tube.
7. Replace the lid on the milk container, turning
it anticlockwise to hook it in place.
If the infuser is difficult to
insert, you must first adapt
it to the right dimensions
by pressing it forcefully
from the bottom and top

DESCALE

Descale the machine when the message
"DESCALE!" flashes on the display.
Important!
Descaler contains acids which may irritate the
skin and eyes.
It is vital to respect the manufacturer's safety
warnings given on the descaler pack and the
warnings relating to the procedure to follow in
the event of contact with the skin and eyes.
Please note:
Use De'Longhi descaler only. Under no
circumstances should you use sulphamic or
acetic based descalers. Their use invalidates the
guarantee. Failure to descale the appliance as
described also invalidates the guarantee.
1. Turn the machine on.
2. Enter the settings menu by pressing the P
button.
3. Press the
symbol flashing on the display) until the
menu arrow is on "DESCALE NO".
4. Press the
the SET symbol flashing on the display)
and "DESCALE YES" appears. Press OK to
activate the function.
5. The message
displayed.
6. Before confirming, empty the water tank
(A12).
Pour the descaler diluted with water
(respecting the proportions indicated on the
descaler bottle) into the water tank.
Place an empty container with a minimum
capacity of 1.5 litres under the hot water
spout.
Important! Danger of burns
Hot water containing acid flows out of the hot
water spout.
Avoid contact with splashes of water.
7. Confirm with the OK button.
8. The message "APPLIANCE IN DESCALE" is
displayed. The descaling programme starts
and the descaler liquid comes out of the water
spout. The descale programme automatically
18
button (corresponding to the
button (corresponding to
"ADD DESCALER" is