Vaderstad Spirit StripDrill ST 600C Series Instructions Manual page 5

ST 400-600C StripDrill
INTRODUCTION
StripDrill is a front tool for the Spirit seed drill and is used for drilling and fertilising on light to medium
soils. The front tool is equipped with so-called StripDrill tines and extra fertiliser coulters located behind
these. StripDrill tills the soil down to a depth of 30 cm and places fertiliser at two different levels while
the machine is drilling. The fertiliser coulters distribute the amount of fertiliser between these two levels.
The depth setting of the fertiliser levels and the working depth of the tines can be adjusted during
operation. The depth setting can be monitored and adjusted from ControlStation during operation.
It is also possible to change the working depth for the fertiliser coulters on the tines.
These instructions constitute a supplementary appendix to the general Instructions for the Väderstad Spirit
400C and 600C with serial numbers starting 909- and must always be used in conjunction with these.
Before bringing the seed drill into service, read carefully all of the safety precautions in the Instructions
for the Spirit 400C and Spirit 600C.
In respect of the machine width, the settings for the Spirit 400C and Spirit 600C in the general Instructions
apply.
01.03.2014 2 5