Vaderstad Spirit StripDrill ST 600C Series Instructions Manual page 22

Instructions and settings
5 Fasten the pin (C) as in "Figure 1.19".
Figure 1.19 Drawbar in position 2, for drilling grain and for transport
6 Remove or push up all spill prevention plates between the StripDrill tines but leave the outer spill
prevention plates where they are.
Figure 1.20
7 Remove the cover (D) from the distributor head by unscrewing the three wing nuts (E).
8 Remove all plugs (F) from the holes on the seed distributor head so that the hoses for all seed drill units
are open.
9 Replace the cover and fit the wing nuts.
10 Adjust the bout marker arms according to the section Bout markers in the Instructions.
22
C
E
D
F
01.03.2014 2