Setting The Spill Prevention Plates - Vaderstad Spirit StripDrill ST 600C Series Instructions Manual

Instructions and settings
1.9.5

Setting the spill prevention plates

B
Figure 1.15
The spill prevention plates which are mounted on StripDrill must work approx. 1 cm below ground level.
Note that the vertical setting of the spill prevention plates should be adjusted in cases of considerable
changes to the working depth.
To adjust the height of a plate, remove the screw (A) and move the holder up or down in the hole series
(B) to the desired position.
20
A
01.03.2014 2