Charging The Battery; Battery Level Indicator; Power Management - UTStarcom Handset User Manual

1.5.2 Charging the Battery

Connect the charger to a standard 100~240V AC wall outlet.
LED Off: Battery not attached to phone
!
LED Blinking fast (500msec): Battery problem. The battery
!
temperature is abnormal.
LED Blinking slow (1sec on, 3 sec off): Battery is charging.
!
Service Light: Charging completed
!
!
Note: In case of a sudden electric power interruption, the travel
charger may not function properly. If this occurs, disconnect the
travel charger from the wall outlet, and try charging again after 5
seconds.

1.5.3 Battery Level Indicator

You can monitor the battery status by checking the battery level indicator.
The number of blocks indicates the battery's condition as follows:

1.5.4 Power Management

Battery
Lithium Ion
800 mAh
The criteria of measurement are in accordance with our internal
specifications.
These operating times are for a new battery. Approximate values may vary
depending on network configuration, signal strength and handset usage.
Full charge
Low charge
Flashing indicates discharged
Mode Talk Time
Digital 160~210 min
Analog 70~90 min
Getting Started
Standby Time
45~140 Hours
11~13 Hours
11