Noise And Vibration - Flex CS 40 WET Manual

CS 40 WET
Specific safe operation guide
 Ensure that the directional arrow marked on the blade corresponds
with the rotational direction of the motor.
 Always keep the blade-securing arbor and collars clean.
 Ensure that the blade-securing means is securely tightened with the
wrench provided.
 Ensure that the portion of work piece that will be cut off has
sufficient room to move sideways. Failure to do so may result in the
cut-off piece binding against the blade.
 Never cut more than one tile at a time.
 Before cutting a tile piece, allow the saw blade to run freely for a few
seconds. If the saw makes an unfamiliar sound or vibrates excessively,
switch it off immediately and disconnect from the power supply.
Investigate the cause or consult the customer service department for
advice.
 Allow the blade to reach full speed before beginning the cut.
 Allow the blade to come to a complete stop before removing any
jammed or off cut material from around the blade area.

Noise and vibration

The noise and vibration values have been determined in accordance with EN
60745.
The A evaluated noise level of the power tool is typically:
– Sound pressure level:
– Sound power level:
– Uncertainty:
Total vibration value:
– when cutting the
– Emission value:
– Uncertainty:
– when cutting the
– Emission value:
– Uncertainty:
CAUTION!
The indicated measurements refer to new power tools. Daily use causes the
noise and vibration values to change.
NOTE!
The vibration emission level given in this information sheet has been
measured in accordance with a standardised test given in EN 60745 and may
be used to compare one tool with another. It may be used for a preliminary
assessment of exposure. The declared vibration emission level represents the
main applications of the tool.
However if the tool is used for different applications, with different accessories
X
X
tile:
a
h
K =
marble:
a
h
K =
dB(A);
dB(A);
K = X dB.
= X m/s
2
X m/s
2
= X m/s
2
X m/s
2
9