Flex CS 40 WET Manual page 7

CS 40 WET
reference.
Before using the power tool, please read and follow:
– these operating instructions,
–the "General safety
enclosed booklet (leaflet-no.:
–the currently valid site rules and the regulations for the prevention of
accidents.
This power tool is state of the art and has been constructed in accordance
with the acknowledged safety regulations. Nevertheless, when in use, the
power tool may be a danger to life and limb of the user or a third party, or the
power tool or other property may be damaged. The power tool may be
operated only if it is
– as intended,
– in perfect working order.
Faults which impair safety must be repaired immediately.
Intended use
The wet/dry saw CS 40 WET
– for commercial use in industry and trade,
– for cutting tile and marble,
– not for cutting metal, wood and plastic,
– to be used with suitable tools recommended by the manufacturer for this
power tool.
Safety instructions for saws
WARNING!
Read all these instructions before operating the product and keep them
in a safe place for future reference.
Always wear safety gear, such as safety goggles, safety mask and ear
protection if necessary.
 Use clamps or another practical way to support and secure the work
piece to a stable platform. Holding the work by hand or against your
body is unstable and may lead to loss of control.
 Do not force the tool. Use the correct tool for your application. The
correct tool will do the job better and more safely at the rate for which is
designed.
 Do not use the tool if the switch does not turn it on or off. Any tool
that cannot be controlled with the switch is dangerous and must be
repaired.
 Store idle tools out of the reach of children and other untrained
persons. Tools are dangerous in the hands of untrained users.
 Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools, with sharp cutting edges are less likely to bind and are
easier to control.
instructions" on the handling of power tools in the
315.915),
is designed
7