Disposal Information - Flex CS 40 WET Manual

The electric power tool features cut-off carbon brushes.
When the wear limit of the cut-off carbon brushes is reached, the power tool
switches off automatically.
NOTE!
Use only original parts supplied by the manufacturer for replacement
purposes. If non-original parts are used, the guarantee obligations of the
manufacturer will be deemed null and void.
When the power tool is being used, the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes are sparking excessively, switch off the electric power
tool immediately. Take your electric power tool to a customer service centre
authorised by the manufacturer.
Gears
NOTE!
Do not loosen the screws on the gear head during the warranty period. Non-
compliance will deem the guarantee obligations of the manufacturer null and
void.
The electric power tool has grease lubrication. Have the grease
changed/topped up by a customer service workshop authorised by the
manufacturer.
Repairs
Repairs may be carried out by an authorised customer service centre only.
If the power cord of the electric power tool is damaged, it must be replaced
with a specially prepared power cord (attachment type X). This power cord is
available from FLEX customer service.
Spare parts and accessories
Other accessories, in particular insertion tools, can be found in the
manufacturer's catalogues.
Exploded drawings and spare-part lists can be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable by removing the power cord.
16
CS 40 WET