Download Print this page
Keysight Technologies N2156A Installation Manual
Keysight Technologies N2156A Installation Manual

Keysight Technologies N2156A Installation Manual

Infiniium uxr oscilloscopes rack mount kit

Advertisement

Quick Links

Keysight N2156A
Infiniium UXR Oscilloscopes
Rack Mount Kit
Installation Guide

Advertisement

loading
Need help?

Need help?

Do you have a question about the N2156A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Keysight Technologies N2156A

  • Page 1 Keysight N2156A Infiniium UXR Oscilloscopes Rack Mount Kit Installation Guide...
  • Page 2: Warranty

    Notices U.S. Government Rights Safety Notices © Keysight Technologies 2018 No part of this manual may be reproduced in The Software is “commercial computer soft- any form or by any means (including elec- ware,” as defined by Federal Acquisition CAUTION tronic storage and retrieval or translation Regulation (“FAR”) 2.101.
  • Page 3: In This Guide

    In This Guide This guide contains instructions for installing the Keysight N2156A Rack Mount Kit. The rack mount kit provides a support shelf and hardware for mounting Infiniium UXR Series oscilloscopes into Electronic Industries Association (EIA) standard 19-inch (487-mm) rack cabinets.
  • Page 4 Attaching the oscilloscope to the support shelf Place the oscilloscope upside down so the feet can be removed to expose support tray mounting holes. N2156A Rack Mount Kit Installation Guide...
  • Page 5 Remove all four feet by pressing firmly on the tab and lifting the foot off. Press firmly on tab Front Foot Removal Press firmly on tab Rear Foot Removal N2156A Rack Mount Kit Installation Guide...
  • Page 6 Attach the support tray to the bottom of the oscilloscope by aligning the four mounting holes on the support tray with the matching mounting holes on the bottom of the oscilloscope as shown. Secure the support tray with the four supplied T20 TORX screws. N2156A Rack Mount Kit Installation Guide...
  • Page 7 Remove the side handles from the oscilloscope. N2156A Rack Mount Kit Installation Guide...
  • Page 8 This distance is equivalent to 1 rack unit Rack units may be designated by arrows. If not, narrow hole spacing indicates start/stop point of rack unit. Rack front view Rack side view N2156A Rack Mount Kit Installation Guide...
  • Page 9 To ensure proper rail nut installation, align with this nut on front of rack. Distance from uppermost nut to lowermost nut is equal Front of rack to 8 rack units. N2156A Rack Mount Kit Installation Guide...
  • Page 10 Attach the track rails to the rack using the four 10-32 flat head screws and a #2 Phillips screwdriver. Track rail (2) 10-32 Flat head screws (4) N2156A Rack Mount Kit Installation Guide...
  • Page 11 Carefully place the oscilloscope (with the support tray attached) onto the track rails. Push the oscilloscope to the rear of the rack until the support tray tabs are against the rack. Slide back until support tray tabs come into contact with rack. N2156A Rack Mount Kit Installation Guide...
  • Page 12 Approximate dimensions of rack mount trim plate pieces Side trim plates Top and bottom trim plates Length 311.15 mm (12.25 in) 482.6 mm (19 in) Width 22.6 mm (0.89 in) 21.625 mm (0.85 in) N2156A Rack Mount Kit Installation Guide...
  • Page 14 This information is subject to change without notice. © Keysight Technologies 2018 Printed in Malaysia September 2018 *N2156-97000* N2156-97000 www.keysight.com...