Table of Contents
Advertisement
OPERATION
Rearview Mirrors
Be sure to adjust the mirrors before starting work. If they are not adjusted properly, you cannot secure the
visibility and may be injured or may injure someone seriously.
Loosen nut (1), screw (2), and bolt (3) installing the mirror, then
adjust the position to give the best view from the operator's
seat.
q Adjust the mirror mount so that it is possible to see any
person (or object of height 1 m and diameter 30 cm) at the
rear left and right of the machine.
q Install the mirror to the mounting position and dimensions
shown. The values given below are reference values for
the range of view.
Mounting position X1: 220mm
X2: 75mm
X3: 100mm
Range of view Y (right side): 2000mm
Range of view Z (left side): 3700mm
Range of view H (height): 3100mm
Mirror A: Must be possible to see hatched portion (A)
Mirror B: Must be possible to see hatched portion (B)
Mirror C: Must be possible to see hatched portion (C)
MACHINE OPERATIONS AND CONTROLS
WARNING
3-87
Advertisement
Table of Contents
