Advertisement
IMPORTANT! IT IS IMPERATIVE THAT CASES BE
LEVELED FROM FRONT TO BACK AND SIDE TO SIDE
PRIOR TO JOINING. A LEVEL CASE IS NECESSARY
TO INSURE PROPER OPERATION.
ALL CASES WERE LEVELED AND JOINED
PRIOR TO SHIPMENT, TO INSURE THE CLOSEST
POSSIBLE FIT WHEN CASES ARE JOINED IN THE
FIELD.
[jl\WARNINGI
TO AVOID REMOVING CONCRETE
LINEUP LEVE LING FROM THE HIGHEST POINT OF
THE STORE FLOOR.
Leveling/Joining Instructions
Check floor where cases are to be set to see if it's level.
Determine where the highest part of the floor is. Cases will
be shimmed off this point. Using case
off and mark on floor the exact dimensions of the case
footprint. Snap chalk line for front and back position of
base rail. Mark location of each joint front and back. Use
a transit to find the highest point along both lines. Mark the
difference, and place the appropriate number of shims.
Wiring Color Code
Standard Case Wire Color Code
Color Dec s ription
■
Ground---------- Green
Anti-S w eat-- - -- -- - - Purple
■
■
L
g ht s ·····························-···························· - ········· O ran g e
i
Rece p tacles •• · ············· - -- - - - ···· Y ello w
T-Stat/Solenoid 230VAC -- - -- Red/Black
■
i:. T-Stat/Solenoid 11 SVAC - --- - White/Black
�
T-Stat/Solenoid 24VAC
F an M otor S•················· - ········· -- - - · Bro w n
■
Blue Conden s in g Unit
Use Copper Conductors Only
430-01-0338 R 101003
4. Installation
FLOORING,
BEGIN
blueprints,
measure
5. Electrical
Color
Red/White
6
Loose Parts
Close-Offs are shipped loose and must
be assembled by installer.
CASE MUST BE GROUNDED
DANGER
BEFORE SERVICING
ALWAYS DISCONNECT ELECTRICAL
POWER AT THE MAIN DISCONNECT
WHEN SERVICING OR REP LACING ANY
ELECT RICAL COMPONENT.
This includes (but not limited to) Heaters and Lights.
Electrical Circuit Identification
Standard lighting for all models will be full length fluorescent
lamps located within the case. The switch controlling the
lights is located at the top right of the case.
Advertisement
