Table of Contents
Advertisement
Cetus
1. Time mode
Press K to enter the "minute" or "hour" setting mode.
Press L to increase the number, press M to
decrease the number; Press and hold for 2
seconds, the number will run continuously.
2. Temperature mode
Press L or M to switch the display unit between
Celsius (range from -20 °C to 50 °C) and Fahrenheit
(range from -4 °F to 122 °F).
3. Speedometer mode
Press L or M to switch the setting unit:
• When "km/h" is displayed, it means
"kilometers/hour".
• When "MPH" is displayed, it means "miles/hour".
• When "/h" is displayed, no speed is displayed.
The display unit of mileage accumulation
trip accumulation
are displayed according to the
speedometer setting unit.
The data displayed at the speed has a certain error
value. The data is for reference only.
4. Mileage accumulation mode
The digital display range is from 0 to 99999.
When the total mileage reaches the full digit of
99999km (62149mile), it will automatically return to
zero and recalculate.
The display unit is set according to the
speedometer; if "/h" is set in the speedometer, this
mode displays the number of hours.
S81201-92800~A
5. Trip accumulation mode
The digital display range is from 0.0 to 999.9.
When the mileage reaches 999.9, it will stop
accumulating (no recalculation).
Press K for 3 seconds to return to zero.
* Setting mode can be closed and the latest setting
can be automatically saved, according to the
following methods:
# Keep still for more than 15 seconds without action.
# Press any key other than K, L, M.
3-3
Control panel maintenance:
Cross screwdriver x 1pcs
Straight screwdriver x 1pcs
1.
Refer to 2-1 Battery power-off: The scooter
power-off treatment.
2.
Remove the two lock points on the top
shroud.
and the
3.
Use the straight screwdriver to open the
control panel.
Service Manual
13
Advertisement
Table of Contents
