Volkswagen 3AB 055 204 Fitting Instructions Manual page 13

Install electrical kit
13. Connect the brown cables with eyelets to the ground point on the vehicle (Fig. 1/3).
14. Route the 9-core cable set alongside the existing cable looms / cable ducts to the vehicle
electrical system control unit at the front left (Fig. 1/1).
15. On the on-board electrical system control unit, unlatch the brown plug (slot C) and open the
contact holder by sliding. Unlatch the following wires and insert into the 3-pin, black bushing
housing located on the wire set:
Wire orange/brown from chamber 16 in chamber 1 enclosed black housing.
Wire orange/green from chamber 15 in chamber 3 enclosed black housing.
Wire black/red from chamber 17 in chamber 2 enclosed white housing.
16. From the wire set, insert the single wires orange/brown, orange/green and black/red into the
proper coloured, vacated chambers 15, 16 and 17 of the brown plug.
17. Reconnect the contact holders with each other by sliding, snapping in the brown cover cap
and plugging the plug back on the on-board electrical system control unit (slot C) and
latching.
18. In each case, plug the open 3-pin black and white housings together.
19. Remove black cover from fuse box (Fig. 1/2) and slide open the purple catch, take the fuse-
protected cable out of compartment 4 (terminal 15) and insert it into the 1-pin housing on the
cable set. Re-insert the individual black/blue cable of the cable set into comportment 4 of the
fuse carrier. Fit the now open 1-pin housings together, insert the following cables into the
fuse-protected side of the fuse chambers as indicated:
- Red/blue cable into chamber 23
- Red/black cable into chamber 25
20. Insert the 20 A fuse in fuse positions 23 and 25.
21. Close the purple catch on the fuse box and push on the black cover.
22. Re-connect ground of vehicle battery.
Passat B7 Limousine & Variant, Coupè 321 823 391 103 - 002 - 43/11 13