Installation - Taramps TS 400X4 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must be
carried out only with amplifier off.
Recommended wire gauge & fuse
Positive / negative power supply cable *________________________________11 AWG
Output cables wire gauge*__________________________________________15 AWG
Remote cable ____________________________________________________ 18 AWG
Protection fuse or circuit breaker________________________________________ 20A
Caution: Using wire gauges less than recommended may result in power loss and wires
overheating .
Check polarity and never reverse power supply cables due to the risk of amplifier
damage.
*Wire gauge calculated considering a 4m maximum length. For longer distance
increase the cable gauges.
It is compulsory to install a protection fuses or circuit breakers as close as possible from
batteries.
12V
Connection example in the output: Stereo + Bridged
Note: In case of driver compression and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer's manufacturer manual).
GND
Subwoofer 4 ohms
4 ohms
4 ohms 4 ohms
Remote Cable 18 AWG
*Illustrative images
RCA Cable
Taramps
RCA Cable
Taramps
4 ohms
If the head unit doesn't have the 4 RCA outputs,
use ''Y'' type cable adapters for properly 4 inputs
connection of TS 400X4 amplifier.
ENGLISH
Head Unit
05