Installation - Taramps DS 4000X4 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must
CAUTION
be carried out only with amplifier off.
Recommended wire
Positive / negative power supply cable _____________________________________1/0 AWG
Output cables wire gauge_______________________________________________11 AWG
Remote cable _________________________________________________________ 18 AWG
Protection fuse or circuit breaker____________________________________________160A
*Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Using wire gauges below the recommendation will result in power loss and
CAUTION
overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
Subwoofer /
Woofer 4 ohms
12V
GND
Note: Required battery bank capacity:
At least 160Ah
gauge & fuse
*
Output connection example: Stereo + Bridged
Note: In case of compression driver and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer's manufacturer manual).
4 ohms
4 ohms
Remote Cable 0,75mm²
4 ohms
The entire aluminum surface of
4 ohms
the amplifier serves as a heat sink.
*Illustrative images
Therefore, avoid contact with this
surface when the amplifier is in
use.
RCA Cable Taramps
Saída RCA
saída a FIO
RCA Cable Taramps
If the head unit doesn't have the 4 RCA outputs,
use ''Y'' type cable adapters for properly 4 inputs
connection of amplifier.
CAUTION
This equipment is not suitable
for use in places where children may be present.
CAUTION
ou
Head Unit
11