Installation - Taramps MD 8000.1 Instruction Manual

Installation

CAUTION: All connections to power supply, input and output connectors must
CAUTION
be carried out only with amplifier off.
Recommended wire gauge & fuse
Positive / negative power supply cable __________________________________2 x 2/0 AWG
Output cables wire gauge________________________________________________7 AWG
Remote cable _________________________________________________________ 18 AWG
Protection fuse or circuit breaker____________________________________________400A
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Using wire gauges below the recommendation will result in power loss and
CAUTION
overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
GND
12V
12V
GND
Examples of connections in the power supply input.
Note: Required battery bank capacity: At least 400Ah
Note: In case of compression drivers and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer's manufacturer manual).
CAUTION
serves as a heat sink. Therefore, avoid
contact with this surface when the
amplifier is in use.
*Illustrative Images
The entire aluminum
surface of the amplifier
CAUTION
This equipment is not
suitable for use in places where children may
be present.
10mm² (7 AWG)
10mm² (7 AWG)
Head Unit
RCA Cable
Taramps
SPEAKER
IN
V Hz Hz Hz dB
4 0.2 10 90 90 10K 35 55 0 +10
GAIN HIGH PASS LOW PASS FREQ. BOOST
OUT CROSSOVER BASS BOOST MONITOR
Outro Amplificador
11