Alto-Shaam FryTech Series Installation Operation & Maintenance page 11

E L E C T R I C A L I N S T A L L A T I O N
1. Refer to the nameplate. Verify the electrical service power. Voltage and phase must match the nameplate
specifications and available electrical service amperage must meet or exceed the specifications listed.
NOTE: W ire gauge, insulation type and temperature rating, as well as type, size and construction
of conduit, must meet or exceed applicable specifications of local codes and of the national
Electrical Code.
To change rotation, swap any two lines of 3 Phase incoming power.
2. The fryer is shipped from the factory wired for 3-phase electrical service.
approved for conversion to single phase. Converting to single phase will void the
warranty and invalidate the ETL certification.
IMPORTANT: field wiring must be routed and secured away from the frypot, tubing, and filter pump
and motor. field wiring must allow access to the rear of the fryer for cleaning and for
access to the oil filter pump motor reset button.
W a r n i n g !
440-480V - 3 Phase Only
The pump motor should rotate clockwise when viewed
from the rear of the fryer.
d A N G E R
ENSURE POWER SOURCE
MATCHES VOLTAGE IDENTIFIED
ON APPLIANCE RATING TAG.
d A N G E R
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
MN-3 5751 • Electric Fryer B attery Ope ration & Care Manual • 9
I N S T A L L A T I O N
This fryer is not