Table of Contents
Advertisement
NTI UNIMUX MULTI-USER KVM SWITCH
INSTALLATION
It is not necessary to turn OFF power to CPUs or monitors during this installation unless RS-232 is going to be connected. All
cables, except for the RS-232 cables, may be hot plugged.
If using RS-232 Control see
RS-232 section
RS232 cables to the CPU. Refer to the owner's manual for the CPU being connected for precautions, if any.
1. Connect the 15HD male cable end from each user monitor to the female 15HD ports labeled "MONITOR x " on the rear of the
UNIMUX switch. See Figure 2.
USER 4
USER 3
USER 2
MONITOR 3
R
S
2
MONITOR 4
3
2
15HD Male
Video Connector
on page 29 for more information. Observe normal precautions when connecting the
Rear View of UNIMUX
NTI
USER 1
R
NETWORK
1275 Danner Dr
Tel:330-562-7070
TECHNOLOGIES
Aurora, OH 44202
Fax:330-562-1999
INCORPORATED
CPU 16
CPU 15
CPU 14
CPU 13
CPU 12
CPU 11
MONITOR 1
VIDEO 15
VIDEO 13
VIDEO 11
MONITOR 2
VIDEO 16
VIDEO 14
VIDEO 12
MONITOR 1
15HD Female
Video Connector
Monitor
Figure 2- Install user monitor(s)
www.nti1.com
CPU 10
CPU 9
CPU 8
CPU 7
CPU 6
CPU 5
CPU 4
CPU 3
VIDEO 9
VIDEO 7
VIDEO 5
VIDEO 3
VIDEO 10
VIDEO 8
VIDEO 6
VIDEO 4
6
CPU 2
CPU 1
VIDEO 1
VIDEO 2
Advertisement
Table of Contents
