Daikin D Series Service Manual page 97

Instruction
To set the clock
1. Press "CLOCK button".
is displayed.
blinks.
2. Press "TIMER setting button" to
set the clock to the present time.
Holding down "
increases or decreases the time display.
3. Press "CLOCK button".
blinks.
Turn the breaker ON
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
NOTE
Tips for saving energy
Be careful not to cool (heat) the room too much.
2
Keeping the temperature setting at a moderate level helps save energy.
Cover windows with a blind or a curtain.
2
Blocking sunlight and air from outdoors increases the cooling (heating) effect.
Clogged air filters cause inefficient operation and waste energy. Clean them
2
once in about every two weeks.
Please note
The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
2
If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
2
Use the air conditioner in the following conditions.
2
Mode
COOL
HEAT
DRY
Operation outside this humidity or temperature range may cause a safety device to disable the system.
88
" or " " button rapidly
Operating conditions
Outdoor temperature: 2MK(X)S 10 to 46 ˚C
3/4MK(X)S –10 to 46 ˚C
RK(X)S –10 to 46 ˚C
RK(X)H 10 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
Outdoor temperature: 2MXS –10 to 21 ˚C
3/4MXS –15 to 21 ˚C
RXS –15 to 21 ˚C
RXH –10 to 21 ˚C
Indoor temperature: 10 to 30 ˚C
Outdoor temperature: 2MK(X)S 10 to 46 ˚C
3/4MK(X)S –10 to 46 ˚C
RK(X)S –10 to 46 ˚C
RK(X)H 10 to 46 ˚C
Indoor temperature: 18 to 32 ˚C
Indoor humidity: 80% max.
C
HOME LEAVE
ON/OFF
TEMP
POWERFUL
MODE FAN SWING
SILENT SENSOR
ON CANCEL
OFF
TIMER
Recommended temperature setting
For cooling:26˚C – 28˚C
For heating:20˚C – 24˚C
If operation is continued out of this range
A safety device may work to stop the operation.
2
(In multi system, it may work to stop the operation of the out-
door unit only.)
Condensation may occur on the indoor unit and drip.
2
A safety device may work to stop the operation.
2
A safety device may work to stop the operation.
2
2 Condensation may occur on the indoor unit and drip.
SiBE12-519
2
1.3
System Configuration