Videx 6300 Series Installation Instructions Manual page 3

6300 Series
Art. 6378
3.5" hands free colour display videophone
MELODY TYPE
1. Press and keep pressed
and then a "beep";
2. After the "beep" press
"beep". There are 9 melodies available. Note: press
3. When desired melody is playing, wait for some seconds: the unit completes the melody and emits a "beep", then the unit emits a
double "beep" that confirms the new setting is properly stored;
4. The unit returns to stand-by mode.
Note: To set the melody it is required that the videophone is connected in a system where the +20Vdc voltage from Art. 893N1 is
always enabled.
NUMBERS OF RINGS
1. Press and keep pressed
unit emits a "beep";
2. Press button as many rings as required: the unit emits a "beep" every time the button is pressed. I.E.: press 3 times for 3 rings.
Default value: 6 rings. Max value: 9 rings;
3. Wait for some seconds: the
4. The unit returns to stand-by mode.
VIDEO MODE SW2
The video mode setup is carried out by the 4 way Dip-Switch accessible from the rear side of the videophone.
Switches 3 and 4 adjust the video signal impedance. When using more than one videomonitor in parallel (without a video
splitter) put both switches in the OFF position on all but the last videomonitor (end of line).
VIDEO MODE
Switches 1,2
VIDEOMONITOR/INTERCOM ADDRESS, VIDEO MODE AND TERMINATION SETUP DSW1
Each intercom is addressed in binary (PHONE ID) using the 8 way dipswitches located on the rear of the unit. Each switch corre-
sponds to one bit which can have a value 0 (OFF) or 1 (ON). Each bit corresponds to a decimal weight depending on the position:
Switch 1 = decimal 1, 2=2, 3=4, 4=8, 5=16, 6=32, 7=64, 8=128. I.E. to set the address 37, put switches 1, 3 and 6 on (1+4+32=37).
SWITCHES
8 7 6 5
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF ON OFF
ON OFF ON ON
Art. 6378 - Installation instructions
button for 10 seconds to enter melody type programming mode: the unit plays the current melody
buttons to select the next melody: a new melody will play for some seconds then the unit emits a
button for 10 seconds to enter numbers of rings programming mode: the
LED turns off and the unit emits a "beep" that confirms the new setting is properly stored;
Mode
Coax
Balanced
4 3 2 1
OFF OFF OFF ON
OFF OFF ON OFF
OFF OFF ON ON
OFF ON OFF OFF
OFF ON OFF ON
OFF ON OFF OFF
buttons only after the melody is over and the unit emits the "beep";
75 OHM VIDEO TERMINATION
Switches 3,4
DECIMAL WEIGHT
128 64 32 16
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0 0
0 0 1 0
1 0 1 1
- 3 -
LED turns on and the
Termination
Enabled
Disabled
8 4 2 1
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 0 0
66251230 - V4.0 - 15/03/19
ADDRESS
1
2
3
4
37
180