Pause; Dialing Stored Numbers; Chain Dialing - Uniden FP101 Operating Manual

Feature-phone series telephone with pre-programmed 5+15 memory

Table of Contents

USING YOUR FP101

PAUSE

During the memory storage procedure you may enter a 4 second delay between

numbers (for accessing a switchboard, or long distance service) by pressing the

button on the Handset at the point in the number sequence you wish to

pause. The

once will increase the length of the pause between numbers.

For example, to dial memory 3 from the telephone

1. Pick up the Handset.

2. Press the

the number stored in this memory location.

NOTE: If you select a memory location that does not have a stored number, the telephone

will not dial.

3. After you have completed the Phone call, place the Handset back on the Base.

On certain occasions, after dialing a number, you may be requested by the party

or service you are calling to enter a special access code, such as when

performing a banking transaction. Simply store this number in another memory

location, refer to "Storing Memory Dial Numbers" on Page 15.

In this way you can recall both numbers that are stored into their own memory

locations at the relevant times.

button counts as one digit. Pressing

button. The telephone will dial

more than

Table of Contents