Velleman HQ Power VDP1500SSM Manual
Velleman HQ Power VDP1500SSM Manual

Velleman HQ Power VDP1500SSM Manual

Professional dmx-controlled smoke machine
Table of Contents
  • Cleaning and Maintenance
  • Technical Specifications
  • Algemene Richtlijnen
  • Reiniging en Onderhoud
  • Technische Specificaties
  • Prescriptions de Sécurité
  • Directives Générales
  • Installation
  • Nettoyage Et Entretien
  • Spécifications Techniques
  • Instrucciones de Seguridad
  • Normas Generales
  • Instalación
  • Limpieza y Mantenimiento
  • Especificaciones
  • Allgemeine Richtlinien
  • Wartung und Pflege
  • Technische Daten

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Quick Links

VDP1500SSM - PROFESSIONAL DMX-CONTROLLED SMOKE MACHINE
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDP1500SSM! If the device was damaged in transit, don't use it and contact your dealer.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• Have a qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is designed for professional use on stage, in discos, theatres, etc. The VDP1500SSM should only be
used indoors with an alternating current of max. 230VAC / 50Hz.
• This device is not suited for permanent operation. Frequent operation breaks will protect the life span of your
smoke machine.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme temperatures, dust and moisture.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
VDP1500SSM
1
VELLEMAN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HQ Power VDP1500SSM and is the answer not in the manual?

Questions and answers

Summary of Contents for Velleman HQ Power VDP1500SSM

  • Page 1 • Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms. • The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming. VDP1500SSM VELLEMAN...
  • Page 2 “listen” to a separate channel number. Changing the settings of one channel will only affect the device in question. In the case of the 1-channel VDP1500SSM, the start address of the first unit is 1, the second unit is 2, the third is 3. d. DMX address setting VDP1500SSM VELLEMAN...
  • Page 3: Cleaning And Maintenance

    • De garantie geldt niet voor schade door het negeren van bepaalde richtlijnen in deze handleiding en uw dealer zal de verantwoordelijkheid afwijzen voor defecten of problemen die hier rechtstreeks verband mee houden. • Laat een geschoolde technicus dit toestel installeren en onderhouden. VDP1500SSM VELLEMAN...
  • Page 4: Algemene Richtlijnen

    3-pins XLR-uitgang van uw controller en de mannelijke 3-pins XLR-ingang van de VDP1500SSM. U kunt meerdere VDP1500SSMs serieel verbinden. De verbindingskabel moet een beschermde kabel zijn met dubbele kern en met een XLR in- en uitgangsconnector. Zie het diagram rechts. VDP1500SSM VELLEMAN...
  • Page 5: Reiniging En Onderhoud

    7. Technische specificaties Voeding max. 230VAC / 50Hz Verbruik 1500W Rookproductie ±150m³/min DMX in-/uitgang 3-pin XLR Opwarmtijd ±10 min Afmetingen 360 x 300 x 135mm Gewicht De informatie in deze handleiding kan te allen tijde worden gewijzigd zonder voorafgaande kennisgeving. VDP1500SSM VELLEMAN...
  • Page 6: Prescriptions De Sécurité

    électrochocs etc. Un usage impropre annule d'office la garantie. 4. Installation • Un technicien qualifié doit installer l’appareil en respectant EN 60598-2-17 et toute autre norme applicable. • La construction portante doit pouvoir supporter 10 x le poids de l’appareil pendant une heure sans déformer. VDP1500SSM VELLEMAN...
  • Page 7: Nettoyage Et Entretien

    1. Serrez les écrous et les vis et vérifiez qu'ils ne rouillent pas. 2. Le boîtier, les lentilles, les supports de montage et la construction portante ne peuvent pas être déformés, adaptés ou bricolés p.ex. pas de trous additionnels dans un support, ne pas déplacer les connexions etc. VDP1500SSM VELLEMAN...
  • Page 8: Spécifications Techniques

    • Asegúrese de que la tensión de red no sea mayor que la tensión indicada en las especificaciones. • No aplaste el cable de alimentación y protéjalo contra posibles daños causados por algún tipo de superficie afilada. Si es necesario, pida a su distribuidor reemplazar el cable de alimentación. VDP1500SSM VELLEMAN...
  • Page 9: Normas Generales

    XLR con una resistencia de 120 de polo 2 a polo 3 (véase figura a la izquierda). Este conector XLR está conectado a la salida XLR del último aparato de la serie. VDP1500SSM VELLEMAN...
  • Page 10: Limpieza Y Mantenimiento

    Volumen de salida de humo ±150m³/min. Entrada/salida DMX XLR con 3 polos Tiempo de calentamiento ±10 min. Dimensiones 360 x 300 x 135mm Peso Se pueden modificar las especificaciones y el contenido de este manual sin previo aviso. VDP1500SSM VELLEMAN...
  • Page 11: Allgemeine Richtlinien

    Gerätes verlängern. • Vermeiden Sie Erschütterungen. Vermeiden Sie rohe Gewalt während der Installation und Bedienung des Gerätes. • Achten Sie bei der Wahl des Installationsortes darauf, dass das Gerät keinem Staub, keiner Feuchtigkeit und extremen Temperaturen ausgesetzt wird. VDP1500SSM VELLEMAN...
  • Page 12 Alle DMX-gesteuerten Geräte brauchen eine digitale Startadresse, sodass das richtige Gerät auf die Signale reagieren kann. Diese digitale Startadresse ist die Kanalnummer, von der das Gerät die Befehle der DMX-Steuerung empfängt und ausführt. Geben Sie die korrekte Nummer ein und lesen Sie diese vom Display auf der VDP1500SSM VDP1500SSM VELLEMAN...
  • Page 13: Wartung Und Pflege

    6. Verwenden Sie zur Reinigung ein feuchtes Tuch. Verwenden Sie auf keinen Fall Alkohol oder irgendwelche Lösungsmittel. 7. Es gibt keine wartbaren Teile. 7. Technische Daten Stromversorgung max. 230VAC / 50Hz Stromverbrauch 1500W Nebelausstoß ±150m³/min DMX-Eingang/Ausgang XLR 3-polig Aufheizzeit ±10 min Abmessungen 360 x 300 x 135mm Gewicht Alle Änderungen vorbehalten. VDP1500SSM VELLEMAN...

Table of Contents