Operating The Uh015Sx In Duplex Mode; Scanning; Open Scan (Os) Mode - Uniden UH015sx Owner's Manual

UNIDEN Model uh015sx UHF CB Radio
Operation

Operating the uh015sx in Duplex Mode

For this example we are adopting CH01 as the channel being used in your area for
repeater use.
To Set Duplex ON/OFF
Press once. The DUP setting
MENU
will flash. Turn the rotary knob to adjust
the setting to or . Press & hold
/ENTER to set. A confirmation
MENU
tone sounds.
The DUP icon appears.
Only channels 01 - 08 are available for Duplex.
Check with your local Retailer for information on available repeaters.
If a button is not pressed within 10 seconds the uh015sx will automatically exit MENU Mode.

Scanning

The uh015sx scanning feature allows you to search the SCAN MEMORY for active
channels automatically.
The scan memory has two main groups; Open Scan (OS) and Group Scan (GS), OS
Scan searches all the channels and frequencies in its memory continuously. GS Scan
has the ability of monitoring a priority channel every 1.5 seconds while searching
channels and frequencies in its memory.
Furthermore, while scanning you can select which channel groups to activate (CB or
POLICE).
Press and Scanning starts.
The SCN icon appears.
You may change the scan direction by
turning the rotary channel selector.
Press again to exit scanning.

Open Scan (OS) Mode

Allows continuous scanning of channels stored in the Open Scan memory. If an active
channel is found, scanning will stop on that channel.
This example shows CH17 active.
If the received signal ceases, the unit will wait 3
seconds for the signal to return, otherwise scanning
resumes. During Scan you may...
Press to hold scan. Press
HOLD
If scan stops on a frequency and you wish to continue then turn rotary channel
selector.
The direction of scan can be changed using the rotary channel selector.
To remove an active channel from scan memory press and hold
scan resumes.
Press and hold /OS/GS for 2 seconds to switch between GS and OS modes.
To deactivate scan, press
When Scan is deactivated the starting channel will be reinstated.
If scan is deactivated while on hold the hold channel will be reinstated.
OS Mode is indicated by the absence of the GS icon.
MENU
ENTER
SCAN SRCH MON
OS/GS BAND/TSQ SQL
again to resume scan.
HOLD
momentarily.
11
SCAN SRCH MON
OS/GS BAND/TSQ SQL
HOLD POL
DCS/CTCSS MEM
POL /MEM and
HOLD POL
DCS/CTCSS MEM