Operation; Setting The Squelch; Monitor - Uniden UH013 Owner's Manual

UNIDEN Model UH013 UHF CB Radio

Operation

Setting the Squelch

Turn the Unit ON by rotating the
volume control clockwise.
The UH013 has 2 Levels Preset
Squelch. It requires no adjustment.
However, if you are in a very high
noise area it may break through.
Press to select the tight squelch
SQT
mode. The SQT icon appears.
Selecting tight squelch mode may prevent the
NOTE
reception of weak signals.
Strong Signals
Medium Signals
Weak Signals
Noise
Think of the squelch control as a
gate. If the squelch is fully closed
no signal can get through.

Monitor

Press the MONI button on the microphone to open the squelch and receive all
weak signals. Press and hold the MONI button for 2 seconds to hold the squelch
open (Monitor Mode). Press MONI again momentarily to cancel.
CAL TSQ DUP
Rotary
Channel
MON SCN GS BCL INS
Selector
SLT SRC HLD
SLCT
SRCH
TSQ
STORE
Strong Signals
Medium Signals
Weak Signals
Noise
If the squelch is fully open 'Monitor
Mode' it allows all signals to get
through - weak, medium and strong
signals and noise.
8
SQT M
MHz
SCAN MEM INST
OS/GS SET/SKIP
DUP
Strong Signals
Medium Signals
Weak Signals
Noise
By setting the squelch to 'threshold',
it blocks out all weak signals and
noise and allows only the required
medium and stronger signals to pass
through.
Strong noise may still break through.
Press
SQT
Squelch' mode. The SQT icon
appears.
VOL
S/RF
SQT
CTCSS
to select the 'Tight
MONI