Operation; Setting The Squelch; Monitor; Selecting A Channel - Uniden UH089sx Owner's Manual

UNIDEN Model uh089sx UHF CB Radio

Operation

Setting the Squelch

Turn the Unit ON by
rotating the volume control
clockwise. Turn the outer
ring of the control to adjust
the Squelch.
You must select a
channel which is not in use before setting the
SQUELCH control. (see below for "Selecting a Channel").
Think of the squelch
control as a gate. If you
turn Squelch fully
clockwise it raises the
'Squelch gate' so high that
no signals get through.

Monitor

Press to open the squelch and receive all weak
MON
signals.
Press again momentarily to cancel.
MON

Selecting a Channel

Turn the Rotary Channel Selector to
select the desired channel.
For your reference a list of the available
channels, corresponding frequencies and
guidelines for their use is printed on page
12. For Australia, Channels 05 and 35 are
reserved for Emergency Calls.
MENU
ENTER
If you turn the Squelch
fully counterclockwise it
lowers the 'Squelch Gate'
to the extent that all
signals get through -
weak, medium and strong
signals and noise.
6
MON
DCS/CTCSS
To set the 'Squelch Gate'
to the desired level, turn
the squelch knob
counterclockwise until you
hear noise. Then carefully
turn the Squelch knob
clockwise until the noise
fades. Now only strong
signals get through.
MON
DCS/CTCSS
MENU
ENTER