Advertisement
SECTION 3
3.1
PAG RMC4X chargers are fitted with an AC input socket conforming to CEE22
(IEC socket). AC supply connection to the charger should be made using only
the standard lead supplied with this equipment.
3.2
PAG RMC4X chargers have been designed for use on AC mains supplies
worldwide, and automatically accept supplies in the range 90V to 265V.
AC mains supply frequency must be in the range 50-60 Hz.
NOTE: PAG RMC4X chargers MUST NOT be operated from a vehicle 12V battery
using the PAG Vehicle Battery-Power Converter, Model No. 9774.
For technical information email support@paguk.com
SECTION 4
4.1
IMPORTANT: Note section 4.16 Supply Failure. PAG RMC4X chargers may
be disconnected from the supply at any time in complete safety and without
damage to the charger or any batteries connected.
4.2
Connect the charger to a suitable supply using the standard lead.
The blue LCD screen will illuminate.
4.3
On power-up, the charger will automatically run a self test program.
4.4
With no batteries connected, the display will indicate 'ABST' on all four
channels.
4.5
When batteries are connected, charging will automatically commence
and the display will indicate 'CHRG' on the appropriate channels.
4.6
Li-Ion batteries are charged simultaneously, using PAG's Intelligent
Parallel Charging program (see 'Charging Times' Section 2.17).
NOTE: Nickel-Metal Hydride batteries are charged sequentially.
8
INSTALLATION
OPERATING INSTRUCTIONS
Advertisement
