Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for PAG V4-IPC
Summary of Contents for PAG V4-IPC
- Page 1 PAG V4-iPC Intelligent Parallel Charger Instruction Manual...
- Page 2 V4-iPC charger. The V4-CPA, Model 9701V, is housed in a compact, impact resistant case and can be connected to any channel on the V4-iPC Charger. Connection to the camera can be made using PAG Adaptor Model 9450, XLR-4 male to female (coiled lead). The V4-CPA outputs 16.8V at 5.5A and is suitable for use with modern broadcast cameras* which...
-
Page 3: Table Of Contents
PAG V4-iPC Intelligent Parallel Charger Instruction Manual CONTENTS SECTION PAGE SAFETY SPECIFICATION INSTALLATION OPERATING INSTRUCTIONS SERVICING & REPAIRS WARRANTY... -
Page 4: Safety
A PDF version of this manual is available for download from the PAG website at www.paguk.com. The PAG V4-iPC charger is not intended for any use other than the charging of batteries as detailed in Section 2 'Specification'. IMPORTANT: Use only on AC supplies 90-265V, 50/60Hz. Supply connection to the unit should be made using only the standard lead supplied with this equipment. -
Page 5: Specification
◗ Maximum output 6A at 16.8V. Recovery Charge Program: This special program will automatically recover a PAG or Sony V-Mount Li-Ion battery where the output has been shut down. Additionally, the program detects batteries having a very low voltage, and initiates a special low charge current. - Page 6 (6.3" x 7.5" x 11.7" approximately). 2.16 Weight: 1.87kg (4.12lb approx.). 2.17 Typical Battery Charging Times: Batteries: Charge Time: 1 x PAG L95 3hrs 15mins 2 x PAG L95s 4hrs 3 x PAG L95s 5hrs 4 x PAG L95s 6hrs 30mins These times are approximate only, and assume batteries are fully discharged.
-
Page 7: Installation
SECTION 3 INSTALLATION V4-iPC chargers are fitted with a mains input socket conforming to CEE22 (IEC socket). Mains supply connection to the charger should be made using only the standard lead supplied with this equipment. V4-iPC chargers have been designed for use on AC mains supplies worldwide, and automatically accept supplies in the range 90V to 265V. - Page 8 If the internal protection circuit of a PAG or Sony Lithium-Ion battery should turn-off, for any reason, the battery display will not operate, and there will be no voltage at the battery terminals. The V4-iPC incorp- orates a Recovery Charge program which will automatically turn the protection circuit back on again.
-
Page 9: Servicing & Repairs
Should the charger re-enter the fail-safe shutdown mode, more detailed investigation is required. Make a note of the error message and seek advice from your nearest PAG dealer or direct from PAG Ltd., London, by telephoning +44 (0)20 8543 3131. -
Page 10: Warranty
In the event of failure of a product covered by this warranty, PAG Limited will repair and calibrate equipment returned to an authorised service facility within the period of the warranty, provided the warrantor’s examination discloses to its satisfaction the product was... -
Page 11: Eu Declaration Of Conformity
EN 50082 - 1 (IMMUNITY) PRODUCT SPECIFIC: EN 55022 - B EN 60555 - 2/3 IEC 801 - 2/3/4 EN 60335 - 1 EN 60335 - 2 - 29 Signed for and on behalf of PAG Ltd. Alan Lavender Chief Executive. Date: 17.1.07... - Page 12 U5087 ISS A / JAN 07 PAG Ltd. T +44 (0)20 8543 3131 565 Kingston Road F +44 (0)20 8540 4116 Raynes Park E sales@paguk.com London SW20 8SA www.paguk.com...
Need help?
Do you have a question about the V4-IPC and is the answer not in the manual?
Questions and answers