Advertisement
SECTION 3
3.1
V4-iPC chargers are fitted with a mains input socket conforming to
CEE22 (IEC socket). Mains supply connection to the charger should
be made using only the standard lead supplied with this equipment.
3.2
V4-iPC chargers have been designed for use on AC mains supplies
worldwide, and automatically accept supplies in the range 90V to
265V. Mains supply frequency must be in the range 50-60 Hz.
NOTE: V4-iPC chargers MUST NOT be operated from a vehicle 12V
battery using the PAG Vehicle Battery-Power Converter, Model No.
9774.
3.3
PAG TECHNICAL SALES AND INFORMATION DESK:
For further information, contact PAG Technical Sales and Information
Desk +44 (0)20 8543 3131 or your nearest PAG Authorised Service
Centre. Alternatively, visit the PAG Web Site at www.paguk.com.
SECTION 4
4.1
IMPORTANT: Note section 4.16 Supply Failure. V4-iPC chargers may
be disconnected from the supply at any time in complete safety and
without damage to the charger or any batteries connected.
4.2
Connect the charger to a suitable supply using the standard lead.
The blue LCD screen will illuminate.
4.3
On power-up, the charger will automatically run a self test program.
4.4
With no batteries connected, the display will show 'ABST' on all four
channels.
4.5
When batteries are connected, charging will automatically commence
and the display will show 'CHRG' on the appropriate channels.
4.6
Li-Ion batteries are charged simultaneously, using PAG's Intelligent
Parallel Charging program (see 'Charging Times' Section 2.17).
NOTE: Nickel-Metal Hydride batteries are charged sequentially.
INSTALLATION
OPERATING INSTRUCTIONS
5
Advertisement
