Doors/Hinges; Preventing Corrosion; Cleaning Kits; Other Monthly Tasks - Welbilt Multiplex FreshBlender Service Manual

Section 4

DOORS/HINGES

Over time and with heavy use, doors and hinges may
become loose. If this happens, tighten the screws that
mount the hinge brackets to the frame of the unit. Loose or
sagging doors can cause the hinges to pull out of the frame,
which may damage both the doors and the hinges. In some
cases this may require trained & qualified service agents or
maintenance personnel to perform repairs.
NOTE: Do not place hot pans on/against the blue ABS liner.
Do not throw items into the storage area. Failure to follow
these recommendations could result in damage to the
interior of the cabinet or to the blower coil. Overloading
the storage area, restricting the airflow, and continuous
opening and closing of the doors and drawers will hamper
the unit's ability to maintain operational temperature.

PREVENTING CORROSION

Immediately wipe up all spills.

CLEANING KITS

Freshblends Stera-sheen starter cleaning kit
(part number WBL-40-001-FRU).
These kits include the following:
• 2.5 gal Shaker Jug
• CIP Intake Line
• Two 4lb Jars of Stera-sheen Cleaner/Sanitizer
• Cups for blender cleaning
• 32 oz Spray Bottle
• Chlorine Test Strips
• Ice Removal Chute Assembly *
* Item included in with unit but not part of cleaning kit
000-BIC-0001Q
Part Number REV00 04/08/2020

OTHER MONTHLY TASKS

Air Filters
Each month check the air filters to be sure they are clean
and allow proper airflow.
Air Filter Locations
First access the rear of the unit. Slide them out one at a
time and inspect them. If they are dirty or light will not
pass through them when held up to light, take to a sink
and wash with dish soap until clean. DO NOT put in a
dishwasher.
Once clean, slide them back into place on the unit and
move unit back into place.
Maintenance
27