Scan.mode.operation; Using The Radio In Scan Mode - Uniden MHS125 Owner's Manual

Scan mode operation
You can save channels into memory and then use scan
mode to monitor those channels from lowest to highest. If the
radio detects a signal on a channel, it stays on that channel
as long as the signal is received; when the signal stops, the
radio continues scanning.
When it detects a signal, the radio stays When it detects a signal, the radio stays
on the channel until you press the on the channel until you press the
Channel Up button or the signal stops. Channel Up button or the signal stops.
08 08 10 10
The radio scans about The radio scans about
5 channels in 0.5 seconds. 5 channels in 0.5 seconds.

Using the radio in scan mode

To activate scan mode, press Scan-Dual.

You must have at least two channels in memory to start a

scan.
You cannot transmit while in scan mode.

To save a channel into memory, select the channel, then

press the MEM-SOS button. The MEM icon displays
whenever you tune to that channel.
To remove a channel from memory, set the radio to that

channel, then press the MEM-SOS button. The MEM icon
no longer displays.
When the radio stays on a channel, press Channel Up to

leave that channel and resume scanning.
To end the scan, press the Scan-Dual button again; the

radio remains on the last scanned channel.
E-10
11 11 12 12 13 13
Uniden MHS125 Radio Owner's Manual
14 14
Resume Resume
scan scan
17 17
15 15