Required Tools And Equipment; Rc Equipment Specifications; Final Adjustments - Twisted Hobbys Crack Yak Lite Series Building Instructions

gravity. You can use adhesive velcro tape or create a suitable cutout to hold the battery. The cutout is
our preferred method, just make sure you do it in the right place (after first thoroughtly testing your
center of gravity).
13. Glue the SFGs (the vertical tabs) into the wing
Installation and setup of your RC and Power System are beyond the scope of this document. If you are new
to the RC hobby, we strongly recommend you to get a help of a more experienced friend. You will be
rewarded by a much smoother and better experience and you will almost certainly have more fun with this
extremely agile 3D indoor and backyard flyer.
You will also need:
-work space
-polythene sheet
-CA glue with kicker, medium and thin
-sharp knife
-1mm drill bit
-heat gun
-small cutters
-small Phillips screwdriver
-about 50cm of a strong sewing string (thread)
RC equipment:
2x servo 6g (rudder, elevator)
1x servo 9g (ailerons)
motor cca 50W, 25-30g (typically one marked 2203 or 2204)
brushless ESC 10-12A
battery 2S 300 – 450 mAh