Installing The Batterypack; Chargingthe Batterypack - Uniden XC630 Operating Manual

Installing the Battery Pack
Black
Wire
to top
v
~
1.
Remove the battery compartment cover on the back of the Handset by
sliding it up.
2.
Connect the Nickel-Metal Hydride Battery Pack by plugging it into the
socket inside the battery compartment. (Note: The connector fits only
one way and requires only a minimal amount of pressure to insert.
Always install the Battery Cable with the Black wire to the top)
3.
Place the Battery Pack inside the compartment and slide the battery cover
back. Make sure the wires from the Battery
Pack
do not get caught in the
cover.
Charging the Battery Pack
The rechargeable Nickel-Metal Hydride Battery Pack included with your
XC630/633 must be charged for approximately 12-16 hours before using the
phone for the first time. Place the Handset on the Base Unit and make sure the
CHARGE LED lights. If the CHARGE LED does not light;
a)
Check to see that the AC Adaptor is plugged in and the wall outlet is
switched on.
b)
Readjust the handset until the CHARGE LED is lights up.
c)
Clean the charge contacts.
17