Table of Contents
Advertisement
4) After the command has finished, you will hear intermittent beeps indicating that
the system is waiting for a command. You may enter another command at this
time from the chart above.
5) When you are finished, press end to exit the system.
Remote access away from home
You can operate your answering system from a remote location using any touch-
tone telephone.
1) Call your telephone number and wait for the system to answer. If the answering
system is off, it will answer after about ten rings and sound a series of beeps.
2) During the greeting message (or a series of beeps when the answering system is
off), press 0 and enter your PIN code within two seconds (see "Setting a PIN
Code" on page 54).
3) The answering system announces the current time and the number of messages
stored in memory. You hear "To play incoming messages, press zero-two. For
help, press one-zero." You will hear a beep.
4) Enter a command within 15 seconds, each command there after must be entered
within two seconds. You may select a command from the following chart:
w w w . u n i d e n . c o m
T H E I N T E G R A T E D A N S W E R I N G D E V I C E [ 6 4 ]
note
•The time stamp will not
be heard until you have
set the time. See
"Setting Day and Time"
on page 25.
•The system will only
playback messages for
four minutes and then
it returns to the
command waiting mode.
To continue playing
your messages, press 0
then 2 again within 15
seconds.
•If you enter an
incorrect PIN code three
times, you will hear a
beep and the system
will return to standby.
•During the remote
operation,
Li n e
Remote
appears on the
display.
Advertisement
Table of Contents
