Uniden TRU8888 Series Owner's Manual page 28

[ 2 7 ] G E T T I N G S T A R T E D
Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system make a trial call. If the call connects, leave the
setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
Switch-over" on page 34).
1) Press the MENU soft key. Select the Global Setup menu,
and then the Dial Mode submenu.
2) Press volume up/down to select
initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
or (the
T o ne Pu l se
w w w . u n i d e n . c o m