DTS 600 Elite Installation Manual page 14

List of audio indications and warnings.
One continuous beep - PCB is damage, replace PCB.
One 1.5 second beep - "Party mode" has been activated.
One 2 second beep
One 2 second beep
One 3 second beep
One 3 second beep
Two 400 ms beeps
Two 1 second beeps - Pedestrian mode was activated.
Three 200ms beeps
Four 100ms beeps
Four 200ms beeps
Five 1 second beeps - Holiday lockout mode has been de-activated.
Twenty 100ms beeps - Motor has stalled or overloaded, then check the following points:
List of LED indications.
- LED ON when open limit is activated. (Gate open).
- LED OFF when close limit is activated. (Gate closed).
- LED flashing SLOW (1 sec. on/1 sec. off) (gate is in motion).
- LED flashes 2 long/3 short continuously (gate is stopped midway).
- LED flashes fast (250ms on/250ms off) continuously. (Gate in overload).
- LED flashes 3 fast flashes every 1.5 seconds. (Battery low, <11VDC).
- LED flashes 1 slow/2 fast continuously. (NO 220 VAC power present).
- Factory defaults have been set.
- Beams are incorrectly wired or faulty when programming the motor.
or Runtime was aborted for whatever reason.
- Holiday lockout mode has been activated.
- Gate triggered when motor is in 3 minute overload lockout.
- Run time programming (calibrating) has been successful.
or No AC power is present, running battery power only.
- Battery power is too low, or
Override function is open or faulty.
- Motor is in holiday lockout.
- Check motor/load fuse (25amp).
- Check motor brushes and armature.
- PCB reader not picking up Magnet on motor.
1) Gate pulling force (should not exceed 15kg)
2) Load pot is set too low (Turn pot completely clockwise)
3) Battery voltage under load (Should not drop more than 1 volt)
4) Gearbox gearwheel.
FOR SAFETY REASONS.
Infra red beams are recommended for
all gate motor installations.
14