Advertisement
WALK WAY DECK ASSEMBLY
Contents of Accessory box #
SCREW BAG 140-059
x4 x4 x4
x8
x2
x18
Do not dive or jump from the step or ladder.
Use BATTERY operated tools to avoid electric shocks.
Install step on flat surface, following the manufacturers
instructions .
Remove step from pool during freezing climate season.
Manufacturer cannot be held responsible for injuries caused
by abusive use of product.
Ask your city about specific regulations that apply to your
above-ground pool and ladder.
250 Industriel Blv,
St-Germain, (Québec),
Canada J0C1K0
955-014
x4
x1
x1
x4
x2
x2
WARNING
Walk Way Step
x2
Required tools
A
1) Flip the Walk Way
so that the steps
are directly facing
the ground.
2) Place the
support tube,
one side at a time,
in the pockets located
in the bottom lip.
3) Flip the step back
to its original usage
position.
4) Secure the support
tube to the step with
the screws provided.
x2
Sand
(Not included )
(not included)
Use small locking
pliers / vice grip
or a wrench 7/16''
REV: 10/02/10
PG. 1
PN: 110-106
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for INNOVAPLAS WALK WAY
Summary of Contents for INNOVAPLAS WALK WAY
- Page 1 Manufacturer cannot be held responsible for injuries caused by abusive use of product. Ask your city about specific regulations that apply to your above-ground pool and ladder. 1) Flip the Walk Way so that the steps are directly facing the ground.
- Page 2 2) Secure the 1) Fill the counterweight counterweight to cover with the the brim with sand. screws provided. 1) Insert the four posts into the step. Secure the posts in place with the bolts,washers and nuts provided. 2) Insert the deck arms over the 2 rear posts.
Need help?
Do you have a question about the WALK WAY and is the answer not in the manual?
Questions and answers