Changing The Digital Security Code; Traveling Out Of Range; Common Issues - Uniden DSS3435+1 Owner's Manual

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from
the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation
that you suspect another cordless telephone is using the same security code or if you are instructed to change this
code by a manufacturer's Call Center Representative, you can change the code. To change the digital security
code:
1. Reset the handset (see Resetting the Handse
2. Re-register each handset (see Registering Accessory Handsets

Traveling Out of Range

During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of
the base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the
connection for 30 seconds after the handset goes out of range. If you move the handset back within range of the
base within 30 seconds, press [ / flash]

Common Issues

If your phone is not performing to your expectations, please try these simple steps first. If these steps do not solve
your problem, visit the customer support page at www.uniden.com.au (Australian Model) or www.uniden.co.nz
(New Zealand model).
Symptom Suggestion
The charge LED won't • Make sure the AC adapter is plugged into the base or the charger (if you have more than
illuminate when the handset is one handset) and wall outlet.
placed in the cradle. • Make sure the handset is properly seated in the cradle.
• Make sure the charging contacts on the handset are clean.
The audio sounds weak. • Move the handset and/or base away from metal objects or appliances and try again.
• Make sure that you are not too far from the base.
t on page 59).
on page 20).
or [ ] to pick up the call again.
[61]