Advertisement
HARDWARE KIT QS-HWR214
ITEM
DESCRIPTION
5
Bolt 1/4-20 Hex Head Black
6
Washer 1/4 Flat Black
Step: 9
Attach adder worksurfaces the same as starter worksurfaces. When all hardware is installed and
the worksurface is aligned, squared and leveled with the uprights, tighten all worksurface
hardware. Do not over tighten. Tie plates are used to secure each starter and adder worksurface
to the next. Position the tie plate over the threaded inserts in the bottom of the worksurface and
attach using 2 each item # 5 and 6 hardware Double-check the worksurface alignment before
tightening this hardware. Do not over tighten.
Please read Caution and Warning Notices found on page 2.
QTY
2
2
8
Advertisement
