Advertisement
Q.S. D4 CRT Platform Standard Laminate
QS-2012622
ITEM DESCRIPTION
1
Bracket Assy. (Heavy Duty)
Swing Arm Assembly 15.75"
2
3
CRT Monitor Platform
HARDWARE KIT #HWR255
ITEM DESCRIPTION
A
Nut 5/16-18 Hex Keps
B
Washer 5/16 Flat
C
Bolt 5/16-18 x .75 SQH
D
Plastic Washer
Step 1:
Choose whether you prefer left or right hand mounting of your Monitor Platform.
Step 2:
Thread two square head bolts item C through the round mounting holes of the bracket assy (item
#1) and secure them with two 5/16 flat washers item B and two 5/16 keps nuts item A leaving
them very loose so you can slide them through the upright channels notch in the preferred vertical
upright extrusions of your workstation. Adjust to the bracket to the height you want and tighten
hardware.
Step 3:
Place a plastic washer item D into the cylinder of the swing arm assembly item #2 and slide the
cylinder part of the swing arm into the bracket by securing it into the bushing in the bracket item
#1.
Step 4:
Place a plastic washer item D into the cylinder of the monitor platform item #3 then set
the monitor platform item #3 on to the swing arm assembly item #2 by seating the cylinder
securely into the bushing.
QTY
1
1
1
QTY
2
2
2
3
28
Advertisement
